Speedfill only one ...
 
Notifications
Clear all

Speedfill only one nozzle works  

  RSS
bobbob
(@bobbob)
New Member
My roboxdual arrived today, the print head with a single nozzle works great (very happy with it printing something other than PLA out of the box!). But when I’ve put the speedfill head on I’m only getting extrusion from the left nozzle.

I’ve done multiple purges but only the left nozzle works.

To note I can’t do any calibration at the moment as the smart reel I received with the printer fell apart as I removed it from the packaging so I’m using some SUNLU PETG

I’ve raised a help desk case but wondering if anyone in here had any ideas?

Quote
Posted : 21st July 2020 5:38 pm
BHudson
(@bhudson)
Former USA Robox Support Moderator

@bobbob You need to calibrate the print head. You can use the PLA, just put the reel on a turntable or other device to do the calibration. Take the center hub out and snap it in place on the reel hub. This will allow you to do the calibration properly. 

Once you have calibrated the print head if you still have problems you will need to report that on your support ticket. 

ReplyQuote
Posted : 22nd July 2020 1:30 am
Pete
 Pete
(@pete)
I am Pete Admin

What BHudson says is correct. The calibrations need to read temperatures from a SmartReel but it is easy to work around this as suggested. You can always write new data to the EEPROM on the SmartReel if a tweak is needed.

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 22nd July 2020 4:00 pm
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.