Head in wrong posit...
 
Notifications
Clear all

Head in wrong position to start printing after ejecting.  

  RSS
Darren Lusty
(@bigdaz)
Eminent Member

I started my Dual printer printing and I had a second material in which wasn't required so it ejected it automatically. The head moved over to the right to eject it, then it started trying to move further to the right to start printing which it couldn't do. I had to stop it and cancel. It seems it needs to move back to home after performing the eject.

Quote
Posted : 31st August 2020 9:09 pm
BHudson
(@bhudson)
Former USA Robox Support Moderator

@bigdaz The head should home before ejecting and then does not need to home again. If the head moved to the right after the eject, something told the printer it had homed again and homed in the wrong place. If it happens again open a support ticket since you may have a problem with your X limit switch.

ReplyQuote
Posted : 1st September 2020 5:08 am
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.