Notifications
Clear all

Camera Support  

  RSS
Steffen-Berlin
(@steffen-berlin)
Eminent Member

Hi!

With the new software version 4.2.0 there is a newer option for using camera at the Root. I didn't use a camera before.

Can you (CEL) tell me / us something about supported cameras.

How to use with Root? Is it Plug&Play?

 

THX

Steffen

Quote
Posted : 25th September 2020 12:45 pm
Pete
 Pete
(@pete)
I am Pete Admin

instructions here @steffen-berlin

https://cel-robox.com/root#timelapse

 

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 5th October 2020 9:26 am
Steffen-Berlin
(@steffen-berlin)
Eminent Member

Hello, Pete,

Thank you very much for the hint.

However, the question remains open for me which alternative USB cameras can be used. The only reference everywhere is to the Logitech C920 and "...that many USB cameras do not work well on the Raspberry Pi."
So again the question to Robox, if there are alternative, well working, USB cameras and which ones would be.
It seems that Robox has already tested cameras and found out that some of them do not work well, it would be nice if they were shared here.

Thanks!

ReplyQuote
Posted : 10th October 2020 1:13 pm
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.