In the DryBox the spools used are hanged on a metal rod. Because one side of the spools is wider than the other the spools will tilt. This will probably work just fine but if you want the spools to be vertical I made a fitting that you can place inside the spool center to fill it up to same diameter on both sides. The spool center is based on this part: https://cel-uk.com/community/show-us-bits/robox-reel-spooler/#post-2465.
I have modified the center for the large spool so that there are four small tabs that secures the center inside the spool. For the small spool, this is not needed. Instead you just insert it with the bottom side first. It relies on that the bottom side always melt just a little so the outer diameter is slightly larger. This is just perfect to make it fit securely.
Latest Post: Head power off Our newest member: Tim Scott Recent Posts Unread Posts
This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.
For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.
