Show us your bits!
 
Notifications
Clear all
Show us your bits!
Last Post Info

Ossum's RC Project

Discussion for Ossum's new RC project.

Topics: 2  |  Posts: 16

Dieselpunk FPV Crawl...

Ossum

Show us your bits!

Printed bits please....or 3D models. Keep it clean people!
Page 1 / 43
Topic Title
Last Post
Views
Posts

paulsroom
By James Swailes
8 months ago
379
4

paulsroom
By Pete
9 months ago
226
2

OCstray

My gear wheel

OCstray, 10 months ago

By OCstray
10 months ago
225
3

Pete
By Pete
10 months ago
239
4

Steffen-Berlin
By Pete
1 year ago
307
4

Vyacheslav
By Vyacheslav
1 year ago
373
5

Roy Henderson
By Pete
2 years ago
407
3

Guy Paquin
By Pete
2 years ago
296
2

Steve N
By Steve N
2 years ago
355
4

paulsroom

Flying maid

paulsroom, 2 years ago

By paulsroom
2 years ago
345
1

Page 1 / 43
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.