Hi all 😊
I was wondering if I could ask a favour? I'm not familiar with how to modify STL files, and I would like to print the following file, but with a few modifications (as it's not very printer friendly at the moment):
At the moment the model can't be printed easily as neither part of the skull has a flat bottom, so I was wondering if someone could make the following changes for me?
- Group upper skull and upper teeth together as one model, but with a small amount sliced off the underside so it's flat enough to stick to my print bed properly
- Group lower skull and lower teeth together as one model, and again with a completely flat bottom so it will stick to my print bed
I will then glue the two parts together once they've been printed.
Thanks so much!
two versions of upper and one of lower attached. Print upper upside down
For official support please create a support ticket using this link www.cel-robox.com/support/
I used the free app on windows called 3D Builder
This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.
For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.