It won't start Auto...
 
Notifications
Clear all

It won't start AutoMaker

   RSS

0
Topic starter
Hello,
I installed Automaker on my PC but it won't start.
I have Win7 32bit.
The installation was successful. But if I double-click on the icon, nothing happens.
I have a printer for a short time. It only came to me yesterday. I bought it second hand and I haven't connected it to a PC yet.
 
5 Answers
0

Hi!

The Version 3.02 was last version that supported Win x32.

Better you use Win x64.

 

Greetings

0
Topic starter

Hello. So far, I do not plan to switch to 64bit
It's an older pc and I have it designed for these things.
I will not buy a new one yet.
But correctly, the program should run independently of the printer connection.

0

Hi!

You will need a 64bit operating system if you want use the actual Automaker version. Downloads – cel-robox (cel-robox.com)

Maybe Linux is an option?

I'm not sure that you can downgrade the Robox firmware successful if you want use the older Automaker version.

0
Topic starter

Ok.
I will either try Linux or buy a win 64bit.
The previous owner had a problem with the printer. That she didn't connect to the pc. After switching on, however, nothing is lit. She did not respond to the PC

0

Additional: 

If you have more and greater problems with the printer CEL-Robox have a support portal: Support : Technical Support Portal (freshdesk.com)

There you can also open a support ticket if you have problems that are not listed in the knowledge base.

Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.