Head related questi...
 
Notifications
Clear all

[Solved] Head related questions  

   RSS

0

Hello CEL support,

The needle valve on my SM head doesn't seem to close completely.
When the head is heated, the melted filament leaks out.
Even if I hold it without doing anything, it will leak out.
How do I adjust the needle valve?

In addition, the status of emissions is checked by Purge.
The attached states.
It is rippling, flat and changing in places.
I think all flat is preferable, I would like your opinion on the Purge situation.
maybe...
Do I need to adjust the head height?
Please tell me how to adjust this head height (Z axis).

Regards,

1587369616-Purge-Line.jpg

@akikazu-taido

Please make sure you have run all three calibrations under the Calibration button in the main toolbar. If after those are run you still have issues, please open a support ticket at www.cel-robox.com/support

Your purge actually looks fine, so I suspect your print head needs to be calibrated.

1 Answer
0

Answered in comments by BHudson. Calibration is important with a new print head and occasionally with some specialist materials.

For official support please create a support ticket using this link www.cel-robox.com/support/

Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.