Animation with retro arcade - Link to
Extruder Newbi Erro...
Clear all

[Solved] Extruder Newbi Error


Topic starter
  • Hi guys could someone please give me some advice about a part I have left over when I opened up my extruder to remove a jam. 
    I opened up my extruder and made a silly mistake not. To open it on a flat surface and a part which looks like a egg timer shape with a oblong whole in the middle and hole at each end has fallen out and I can’t see where it goes back, any help with this would be appreciated


2 Answers

Try this: The addendum at the end will show you specifically what you are looking for.

Topic starter

Many thanks for your help, that has saved me so much time, all works well now

Regards Brian 😀 


This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.