Notifications
Clear all

Nozzles  

  RSS
daniel wilson
(@daniel-wilson)
New Member Customer

Hello i am trying to source a 0.8 nozzle for my single material head dual nozzles as I have a damaged 0.8 and needed ASAP please help

Quote
Posted : 3rd November 2020 1:29 pm
Topic Tags
BHudson
(@bhudson)
Former USA Robox Support Moderator

@daniel-wilson The Robox print head nozzles aren't user replaceable. They are match-fitted with the needle valve during the factory installation and without that match fit they will not seal again. You will need to replace the print head. 

ReplyQuote
Posted : 4th November 2020 2:50 am
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.