3rd party PETG help...
 
Notifications
Clear all

3rd party PETG help!  

  RSS
Juan Barbini
(@juan15pablo)
Trusted Member

Hi there!

I cant configure properly the new PETG filament. Here in Argentina we have several filaments companys, now I am trying this PETG that seems to be a good quality filament but as you can see the cylinders arent smootly, and it has a lot of string inside (not between pieces if I print more than one, and there is no leak on the nozzle).

I did several tests changing nozzle temps, filament multiplier and feed rate multiplier, but I cant find the right config.
Any advice?
Actually I have setted to:
Nozzle 1st: 250
Nozzle: 245
Bed 1st:70
Bed: 65
Ambient: 30
Filament Multiplier: 0.95
Feed rate Multiplier: 0.95
I tried CEL Default PETG configs, but none of them worked fine...
 
Any advice?
1600102042-IMG_20200914_101223693.jpg
Quote
Posted : 14th September 2020 5:47 pm
BHudson
(@bhudson)
Former USA Robox Support Moderator

That looks like poor filament diameter control from the manufacturer, though I can't tell for certain. The first thing I recommend is to test with CEL or ColorFabb filament. If you get good results from those, you know it is the filament. 

If you get the same results, it will be a hardware issue, possibly the extruder wearing out.

ReplyQuote
Posted : 15th September 2020 3:50 am
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.