Add other Cura feat...
 
Notifications
Clear all

Add other Cura feature to AutoMaker  

Page 3 / 3
BHudson
(@bhudson)
Former USA Robox Support Moderator

@kamil1 Yes, that is correct. The free version of AutoMaker does not have the options that the Pro version does.

 

ReplyQuote
Posted : 2nd April 2020 2:21 pm
Juan Barbini
(@juan15pablo)
Trusted Member

 

@chris

I would like to enable z-hop option and iroing on Automaker, could you help me?

ReplyQuote
Posted : 12th December 2020 7:47 pm
BHudson
(@bhudson)
Former USA Robox Support Moderator

@juan15pablo Z-Hop is under Hop after Nozzle Close, Check the box and set the hop height.

ReplyQuote
Posted : 13th December 2020 6:59 pm
ollycuff
(@ollycuff)
Active Member

@chris Hi Chris, I followed the instructions but it appears my print profiles disappeared within automaker after doing the changes. Any ideas?

 

 

Thanks 

 

Olly

ReplyQuote
Posted : 19th December 2020 8:38 pm
Page 3 / 3
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.