Disapointed I was informed that the Cel Drybox was discontinued. Not because it was bad in any way but becuase the had to be made in a too large number for Cel to afford production.
I am not a hobby user so I like to buy my tools and spend less time for setting up the produvtion and as I know how important it is to has dry filements a drybox would be a perfect add-on to my just ordered RoboxPro.
Does anyone know about a decent alternative for Cel drybox? An alternative that I can buy from Europe. If no I may have to make one myself and in that case the question goes to what to build? I think it is best if the filament can be stored inside the drybox even then printing. I will use empty filaments on the printer and program them to current used material.
If there are no other alternatives (the only good one I found is Kodaks Smart 3D Multimaterial dryer but it is extremely expensive) I must consider making my own. Suggestions for good DIY versions is appreciated.
This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.
For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.