CEL AutoMaker is Released under an Open Source Licence
When we started the Robox project we saw some of our competitors closing the source on their software and hardware after being bought up by large corporations. Although we could [...]
When we started the Robox project we saw some of our competitors closing the source on their software and hardware after being bought up by large corporations. Although we could [...]
During the development of 'Mote' we purchased a few different screens to see which was best combination of cost, size and function. We finally decided to go with a 5" [...]
Last week we released a head with an additional blower fan attached to the side - there is a blog here to read about it. To make this work, we [...]
We have developed a head that has an external blower fan which is directed over the nozzles for use with PLA and other low temp materials such as PCL. This [...]
If you've downloaded the latest version of AutoMaker then you may have noticed that we've activated Spiral Printing for you to play with. Robox is particularly good at spiral printing [...]
CEL MD and Design Engineer Chris Elsworthy talks about the beginnings of CEL, the POWER8workshop and the reasons Robox was created. Watch Robox print one of the parts from our [...]
We were asked by element14 to design a case to fit the new Raspberry Pi 2 The images below show the case, it was printed in 2 halves, we paused [...]
I hope to think so when it comes to engineers, as I'm 6'8" tall! But when it comes to 3D printers’ size really isn’t everything. There are now two common [...]
I was really excited to meet Gordon Attenborough and Mark Reynard from The Institution of Engineering and Technology (IET), to be interviewed about the fact the Robox looks set to [...]