CEL AutoMaker is Released under an Open Source Licence
When we started the Robox project we saw some of our competitors closing the source on their software and hardware after being bought up by large corporations. Although we could [...]
When we started the Robox project we saw some of our competitors closing the source on their software and hardware after being bought up by large corporations. Although we could [...]
During the development of 'Mote' we purchased a few different screens to see which was best combination of cost, size and function. We finally decided to go with a 5" [...]
Last week we released a head with an additional blower fan attached to the side - there is a blog here to read about it. To make this work, we [...]
We have developed a head that has an external blower fan which is directed over the nozzles for use with PLA and other low temp materials such as PCL. This [...]
Improving 3D-printing speed while achieving high levels of detail is what many design engineers strive for. But did you know that both a print’s speed and detail largely depend on [...]
A common misconception is that 3D printing is complicated and requires a specific skill set. Perhaps unsurprisingly, UK businesses often cite the skills gap as one of the main barriers [...]
When it comes to 3D printing, you need to think about economies of scale. As our white paper explains, it isn’t just your output-to-cost ratio that matters, but also [...]
‘The bigger, the better’ is a phrase all too often used, but when it comes to 3D printers, you don't necessarily need to start big to think big. As our [...]
Content: A multiple 3D printer set-up, or stack, will improve the effectiveness of the design process and ultimately open-up all kinds of creativity for design engineers while remaining cost-effective. [...]